Question
Download Solution PDFWhat is the tail offset required in lathe to produce a taper of 60° over a length of 0.2 m on a shaft of overall length of 1 m?
Answer (Detailed Solution Below)
Detailed Solution
Download Solution PDFConcept:
Offset in tailstock is given by;
where, S = Tail offset, α = Taper angle, Lw = workpiece length,
Calculation:
Given:
α = 60°, Lw = 1 m,
S = 1 × sin 30°
S = 1 sin 30°
Last updated on May 30, 2025
-> The ISRO Technical Assistant recruitment 2025 notification has been released at the official website.
-> Candidates can apply for ISRO recruitment 2025 for Technical Assistant from June 4 to 18.
-> A total of 83 vacancies have been announced for the post of Technical Assistant.
-> The Selection process consists of a written test and a Skill test.
-> Candidates can also practice through ISRO Technical Assistant Electrical Test Series, ISRO Technical Assistant Electronics Test Series, and ISRO Technical Assistant Mechanical Test Series to improve their preparation and increase the chance of selection.